Preparing For Use - nature7 TULIP Traducción Del Manual Original Para Su Uso

III. Preparing for use
IMPORTANT INFORMATION PRIOR TO USE:
Place the aroma diffuser on a firm even
surface.
Always use fresh clean drinking water in
the appliance. We recommend leaving tap
water to stand for a while to evaporate
the chlorine. The water that is used
should not be too hard.
S TE P 1
Insert the DC connector of the power
cable into the socket on the underside
of the aroma diffuser and then stand the
appliance on a firm level surface (fig. 2).
S TE P 2
Remove the cover of the aroma diffuser
and pour clean water into the water tank.
Make sure that the water level does not
exceed the maximum water level mark
and add 2 to 3 drops of essential oil into
the water (fig. 3).
GB
28
MAKE SURE THAT THE WATER LEVEL
DOES NOT EXCEED THE MAXIMUM
WATER LEVEL MARK
S TE P 3
Place the cover on to the aroma diffuser
(fig. 4).
S TE P 4
Insert the power adapter plug into
a mains socket with voltage (fig. 5).
•
AT TENTION
Do not tilt the aroma diffuser or
pour water out of it though the
mist outlet while it is in operation.
Buttons (fig. 6):
LIG HT BU T TON
(fig. 6, position 1)
First press: The colours will gradually
change.
Individual subsequent presses:
An individual unchanging colour can be
set as required.
G E N E R ATE MIS T BU T TON
(fig. 6, position 2)
First press: The highest mist generation
intensity will be set and the light with
changing colours will be turned on.
Second press: A lower mist generation
intensity will be set and the light with
changing colours will be turned on. The
aroma diffuser will turns off automatica-
lly when the water is used up.
Third press: Mist generation will be deac-
tivated and the light will turn off.
Holding down: The light will turn off
after holding down the button for approx.
3 seconds.
NOTE
The light can be turned on even without
water in the water tank.
NOTE
By repeatedly pressing the light control
button, a single colour that is required
can be set during mist generation, or,
alternatively, holding down the light
control button will turn off the light
during mist generation, and mist will be
generated without the light.
GB
29