SEACHOICE 71181 Instrucciones De Ensamblaje E Instalación

SAVE THESE INSTRUCTIONS
HARDWARE INCLUDED
4 Ea. 1/4-20 x 2-1/4" Machine Bolt
15 Ea. 1/4-20 Washers
7 Ea. 1/4-20 Lock Nuts
4 Ea. White Nylon Spacers
2 Ea. 1/4-20 x 2-1/2" Machine Bolts
3 Ea. 1/4-20 x 1-1/4" Machine Bolts
1 Ea. 90° Bracket
5 Ea. #14 x 1-1/4" Lag Bolts
1 Ea. Angle Mount
2 Ea. 1/4-20 Large Flange Washers
2 Ea. Grab Rails
INSTALLATION INSTRUCTIONS
1. Attach stainless grab rails to platform with 2 ea. ¼-20 x 2-1/4" bolts,
washers and 1/4-20 lock nuts. For Outboard application use single grab
rail with 1/4-20 x 2-1/4" bolt and angle mount with 1 ea. 1/4-20 x 1-1/4"
bolt, washer and lock nut attached to the platform.
2. Position 90° bracket on platform and mark holes and drill with ¼" drill bit.
Install bracket to platform with 2 ea. 1/4-20 x 1-1/4" bolts, washers and
lock nuts. (Outboard application only)
3. Position platform on boat and mark upper rail hole(s) and drill
with 1/4" drill bit.
4. Mount top of rail(s) with 1/4-20 x 2-1/2" bolt, large flange washer
and lock nut.
5. Position 90° bracket to boat and drill 3/16" pilot, install 3 ea. #14 x 1-1/4"
lag bolts. (Outboard Only)
6. Drill 3/16" pilot hole in boat for lower grab rail (or angle) mount and
attach with #14 x 1-1/4" lag bolts.
NOTE: All holes should be sealed with waterproof sealer.
Universal Swim Platform
SEACHOICE PRODUCTS
Pompano Beach, FL U.S.A.
Ph: 954-581-1188 • Fax: 954-581-0901 • seachoice.com
Made in China • Hecho en China • Fabriqué a Chine
Models: 71181, 71191
Figure 1 Inboard/Outboard
Aplicación Interior/fueraborda
Application Interiérieure/Hors-bord
Figure 2 Outboard Application
Aplicación Fueraborda
Application Hors-bord
NOTE: In Figure 2, installation shown is for
Starboard assembly application, reverse
grab rail angle mount and 90° bracket for
Port side.
71201, 71211
71351, 71361
0111_Rev