Publicidad
MIC INPUT - Input socket to connect with your microphone using an XLR or jack cable. Note this amplifier does not provide
phantom power, meaning only dynamic microphones can be used.
TONE use this dial to adjust the tone of the microphone input. Fully anticlockwise will give a warm sound with increased bass
frequencies, fully clockwise will give a brighter sound with increased high frequencies.
MIC LEVEL use this dial to control the volume of the microphone.
GUITAR INPUT - Input socket to connect with your guitar using a 6.5mm jack cable.
BASS use this dial to adjust the low frequency level, with a cut/boost of +/-15dB
MID use this dial to adjust the middle frequency level, with a cut/boost of +/-15dB.
MID FREQ use this dial to adjust the frequency of the mid frequency controlled by MID dial (9). Fully anticlockwise = 200Hz,
fully clockwise = 5KHz.
TERBLE use this dial to adjust the high frequency level, with a cut/boost of +/-15dB
CHORUS SPEED use this dial to adjust the chorus speed of the chorus (vibrations per second).
CHORUS ON/OFF SWITCH this button switches the chorus effect on and off.
CHORUS ON/OFF LAMP this LED lamp illuminates when the chorus has been switched on.
CHORUS DEPTH use this dial to adjust the amount of chorus added to the output sound.
MIC REVERB use this dial to change the amount of reverb added to the microphone channel. Turning the dial clockwise
increases the decay time, turning anticlockwise
REVERB ON/OFF SWITCH this button switches the reverb effect on and off.
REVERB ON/OFF LAMP this LED lamp illuminates when the reverb has been switched on.
GUITAR REVERB use this dial to change the amount of reverb added to the guitar channel. Turning the dial clockwise
increases the decay time, turning anticlockwise
5 BAND GRAPHIC EQ use these sliders to adjust the volume of specific frequencies +/-16dB. Frequencies are 100Hz, 400Hz,
1KHz, 3KHz, 6KHz.
AUX INPUT - Input socket to connect with external media players, such as mp3 players using a 3.5mm jack cable. Note this
input will accept a stereo jack cable.
MASTER VOLUME use this dial to control the overall volume sent to the speaker/headphones.
POWER use this switch to turn the amplifier on and off.
AC POWER INPUT Connect the amplifier to a power source using the provided IEC cable. Heed all safety warnings in this
manual. This amplifier operates at 220-240V, 50/60Hz. Check your local power source before plugging the device in. For more
advice, check the specifications below, or contact the Gear4music customer service team.
FUSE Only ever replace with a like-for-like fuse. For more advice on the fuse used in this amplifier, check the specifications
below, or contact the Gear4music customer service team.
EXTERNAL SPEAKER powered output socket to connect to an additional passive speaker (left and right channels available).
Before plugging in, check power and impedance ratings match this amplifier. Do not plug this connection to an additional
amplifier.
FOOTSWITCH input socket to connect a single button footswitch. The footswitch can turn on and off the chorus or the reverb,
and can be configured using the toggle switch immediately below the input socket.
LINE OUT unamplified output socket to connect to an additional power amplifier or active speaker.
EFFECTS RETURN input socket to connect to an external effects unit using a 6.5mm jack cable.
EFFECTS SEND output socket to connect to an external effects unit using a 6.5mm jack cable.
Publicidad
