Descargar Imprimir esta página

Publicidad

Enlaces rápidos

Cable
SECURITY
Diameter
KWIK-LOC
SKL100
RWC3
SKL150
RWC4
SKL200
RWC6
SKL600
RWC8
Rize Enterprises, LLC · Tel: 631-930-7532 · www.rizellc.com
SKL100•SKL150•SKL200•SKL600
THE SECURITY KWIK-LOC
SELF LOCKING CABLE JOINER
Assembly Instructions and Warnings
Unscrew the locking nut and set screw until the release pin is
pushed back fully. Pull reelease pin back and pass wire through
Security Kwik-Loc. Failure to pull adjustment pin first may
cause damage to serrated teeth and reduce holding capacity.
Pull adjustment pin back and pass wire back through
Security Kwik-Loc. Push through at least 6" of wire rope.
Always confirm engagement of Security Kwik-Loc on wire
before applying load by pushing the adjustment pin in the
opposite direction of the arrows on the cable lock and then
pulling the cable also in the opposite direction of the arrows on
To adjust, take the load off and pull the tail slightly to
disengage teeth, then release using adjustment pin.
Construction
7 x 7
Galvanized Steel*
7 x 7
Galvanized Steel*
7 x 19
Galvanized Steel*
7 x 19
Galvanized Steel*
Loop wire through anchor.
the cable lock.
Tighten the locking nut and bolt until
the release pin can no longer be moved.
Material
Safe Working Load Range at
TM
5:1 Safety Factor
25-150 lbs. (12-100 kg)
25-250 lbs. (12-114 kg)
50-640 lbs. (25-180 kg)
50-1,100 lbs. (25-500 kg)

Publicidad

loading

Resumen de contenidos para Rize SKL100

  • Página 1 RWC4 7 x 7 Galvanized Steel* 25-250 lbs. (12-114 kg) SKL200 RWC6 7 x 19 Galvanized Steel* 50-640 lbs. (25-180 kg) SKL600 RWC8 7 x 19 Galvanized Steel* 50-1,100 lbs. (25-500 kg) Rize Enterprises, LLC · Tel: 631-930-7532 · www.rizellc.com...
  • Página 2 · To ensure hanging system integrity and safety, use only RIZE cable · Always pull adjustment pin back before passing wire rope through RIZE cable lock. Failure to pull adjustment pin first may cause damage to serrated teeth and reduce holding capacity.

Este manual también es adecuado para:

Skl150Skl200Skl600