UPRIGHT FREEZER SHOWCASE
Original Instructions
t
HSC300N
2. GENERAL APPEARANCE OF YOUR PRODUCT
I
J
K
A1
A3
A2
3. INSTALLATION OF YOUR PRODUCT
Selecting the place of installation
1. The operating environment of the product is very important for the smooth operation of your product. While selecting the operating environment, do not place
your product exposed to outdoor environment (on the street, avenue, etc.).
2. Be careful for not obstructing the lower shutter of the product with materials such as cardboard, box etc. for a proper cooling. (Picture 3)
3. Place the product at least one (1) meter away from heat resources (stoves, radiators, electric heaters etc.). (Picture 4)
4. Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Picture 5)
5. Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to your product's glass. That means an increase in the energy consumption.
6. Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of your product.
7. While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and back of your device.
WARNING!
•
In very humid environments, ensure that floor and wall of the place where your product is located, are not affected by water.
•
If the installation is performed by the seller, the seller shall inform the consumer about the suitable locations for installation and make suggestion, but the
consumer shall give the final decision on where the installation will be made. This above mentioned process shall also be stated on the relevant installation
from the authorised service provider. In case of any loss arising from the place of installation of the product according to the final decision given by the
consumer, all responsibility related to such loss shall belong to the consumer.
Your product gives the best cooling performance according to the climate condition under the conditions given below. Therefore, be careful that the temperature
of the environment where your product will operate is at these levels.
Climate Class
Class 4
PICTURE 3
(IM)961-000669_HSC300N_GB&DE_IM_V5_161121.indd 7
A4
Temperature Range
+16°C to 30°C
PICTURE 4
A
B
A
Control panel
C
B
Lock
D
C
Lighting
D
Fixed shelf x 6
E
Glass door
E
F
Door handle
G
Discharge plug
F
H
Kick plate
I
Wall distance holder (back side)
J
Air vent (back side)
K
Compressor (back side)
Accessory:
G
H
A1
Power "ON" indicator
A2
Lighting ON/OFF switch
A3
Thermostat control knob
A4
LCD display (inside temperature)
Humidity
55% Rh
PICTURE 5
- 7 -
Key (included)
Battery (LR44 x 2 included)
11/21/16 2:21 PM