Bt Operation; Aux-In Operation; Mic Jack Operation - auna ULTRASONIC CD Manual De Instrucciones

Important: The USB port is intended for data transfer only, other devices
cannot be used with this USB connection. The use of USB extension cords
is not recommended. Don't plug the USB from the unit when playing or
reading the USB device.

BT OPERATION

1. Press the FUNCTION button on unit to switch to BT function, the LCD will
display "BT" and the pair indicator will flash at high speed.
2. Turn on the BT function on the device, scan the unit "KCD818BT" and
connect, then input the password 0000 if required, the pair indicator
keep light up to indicate connection done, and the display will show "bt".
Press Play to start playback.
3. Rotate the VOLUME knob on the unit or adjust the volume on the
external device to increase or decrease the music volume to your desired
level.
4. Press the /PAIR/SCAN button to disconnect BT, Press /PAIR/SCAN
button again to play music.
Note: The BT works best within 10 meters in open air.

AUX-IN OPERATION

1. Press the FUNCTION button on unit to select the "AUX" mode.
2. Connect your audio device to the AUX IN jack on the top panel of the unit
with an AUX IN cable.(audio cable is not included)
3. Rotate the VOLUME knob on the unit or adjust the volume on the
external device to increase or decrease the music volume to your desired
level.
4. Control the playback with your audio device.

MIC JACK OPERATION

Microphone input is available in all modes.
1. Connect your microphone to the 6.3mm MIC JACK found on the top
panel of the unit.
2. Press the MIC VOL.+/- button on the unit to increase or decrease the
microphone volume.
3. Press the ECHO Button to turn on or off the echo effect of the
microphone.
EN
33