MusicMan BT-X42 Manual De Usuario página 4

Pairing
 Turn on the Bluetooth function on your Bluetooth-enabled device
and set it to search for Bluetooth devices.
 Power off the earphones. Now press and hold the
button [7]
for 4 seconds to enter pairing mode. The LED indicator flashes RED
and BLUE as your earphones searches for Bluetooth-enabled
devices.
 Select and connect to "MusicMan BT-X42" from the list of found
devices. When paired, the LED Indicator flashes BLUE every 4
seconds and the earphones enters standby mode.
Operation
How to change Bluetooth devices
 Your earphone automatically reconnect to the most recently
paired device when it is powered on.
 To pair a new device, first you must disconnect the Bluetooth
function of the current device. See the instructions of your Bluetooth
device for details.
General hints before start using the earphones
 Do not wear earphones while driving a vehicle or cycling. This can
create a traffic hazard and is not allowed in some countries.
 To protect your hearing  do not listen at high volume (extended
high-volume listening can lead to permanent hearing loss). Set the
volume to the lowest setting and then adjust to a comfortable level.
 Avoid increasing the volume (your ears adapt to volume, so a
level that does not cause discomfort could still damage your
hearing).
How to use ANC (Active Noise Cancellation)
To enable or disable the ANC just press the button [5]. The
WHITE LED will shine when ANC is enabled. The WHITE LED is off
when ANC is disabled.