Descargar Imprimir esta página

Coleman 011-2026-2 Manual Del Usuario página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

Congratulations on your Coleman® solar product purchase. This product is designed to the highest technical
specifications and standards. It will supply years of maintenance free use. Please read these instructions
thoroughly prior to installation, then store in a safe place for future reference. If at any time you are unclear about
this product, or require further assistance please do not hesitate to contact our trained professionals operating the
customer support line 1-888-478-6435 or email to
Crystalline Solar Panel 30W
Power Rating: Maximum rating 30 Watts (under ideal conditions)
Current: 1.75 Amps @ 17.1 Volts
Specifications:
12 Volt output
Tempered glass panel
Aluminum frame
Fully weatherproof design
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION
Warning:
• Avoid electrical hazards when installing, wiring, operating, and maintaining your solar module. The solar module
included generates DC electricity when exposed to sunlight or other light sources.
• For use in 12-Volt systems only
• Observe proper polarity throughout entire power cable wiring route
• Work Safely. Do not wear jewelry when working with electrical or mechanical equipment. Use protective
eyewear when working with batteries or drills. Use extreme caution when on ladders or on a roof.
• Follow all safety precautions of the battery manufacturer. Some batteries can release flammable hydrogen gas.
Do not produce sparks when working in locations where flammable gases or vapors exist. Shield skin and eyes
from battery acid. Wash thoroughly with water if skin or clothing come in contact with acid or any corrosive matter,
which may have accumulated, on the battery. Keep the terminals and casing clean.
• Use of a charge controller is always recommended
• Do not attempt to charge non-rechargeable batteries
• When disconnecting, always disconnect battery last
Connecting Solar Panel to Battery
-
It is always recommended to use a solar charge controller.
Please follow these easy installation steps
For Junction Box without wires exposed:
1. Open the junction box on the back of the panel
2. Follow the indicated polarity (+/-)
3. Select the required length of wire
4. Either wrap the wire around the screw terminals or utilize 'Crimp Connectors'
5. Screw down the screw terminals ensuring a tight clean connection.
For Junction Box with exposed wires:
1. Follow the indicated polarity (+/-)
2. Select required length of wire
3. Connect wires and use either wire nut and/or electrical tape for tight connection
Once you have identified the polarity of your wire:
Connect Positive wire to the POSITIVE on your Solar Charge Controller
Connect Negative wire to the NEGATIVE on your Solar Charge Controller
Wire 'twist nut caps' may be required for this connection
Caution: Always double check you have the correct polarity prior to connection to your 12 Volt battery.
Connect your solar charge controller to your 12 Volt battery again following correct polarity
Your 12 Volt solar panel will now begin to charge (under full sun)
info@sunforceproducts.com
Connecting to a Charge Controller

Publicidad

loading