Refreshing Carpets - Hoover SteamScrub 3-in-1 Manual De Instrucciones

Using your machine:

Refreshing carpets

1
Place the
microfibre pad
on the floor white
side facing up.
Place steamer
onto pad making
sure the entire
pad covers
the floorhead.
2
With microfibre pad
attached, slide the
floorhead into the
carpet glider, then push
the back of the floor-
head downwards into
the clip to secure. The
carpet glider should
only be used when
refreshing carpets.
Always test on an inconspicuous area of flooring first before using solution.
Don't over fill the clean twin tanks or exceed the maximum amount required.
water tank. Always top up with water in good time.
3
Plug the steamer into
mains and slide the
On/Off switch to "On".
The green light will
illuminate when it is
ready to use. The
steamer will automati-
cally set to Max steam
(no solution).
• IMPORTANT •
Don't use the steamer without water in the
4
To refresh your
carpets press the
button on the con-
trol panel to select
Steam only LOW.
Do not use
solution when
refreshing carpets.
5
Pull handle
backwards
to recline.
see next page
14