OttLite OTL13DWS Guia De Inicio Rapido

13w Executive Desk Lamp
OTL13DWS
INS80010 REV080608
ENGLISH
CONGRATULATIONS! positioned over the tab (F) located on
You've purchased the finest in the socket assembly (G). Refer to the
natural lighting technology with your diagram for proper shade position.
new OttLite product.
®
5. Remove the shade by pulling it
STEP 1: PRODUCT straight out from the socket assembly.
REGISTRATION FORM
Please complete the enclosed 6. To install a tube (H) in the socket,
Product Registration Form and return grasp the tube firmly in your hand,
it today by mail, or register online by position the tube so that it is aligned
going to: www.ott-lite.com/warranty. as pictured in the diagram, then push
the tube straight into the socket until
WARNING: To prevent electric it "snaps" into place.
shock, make sure the lamp is not
plugged in until all assembly steps 7. To remove a tube already installed
are complete. in the lamp, grasp it firmly in your
hand and pull it straight out of the
STEP 2: LAMP ASSEMBLY socket. Do not twist or turn the
1. To adjust the tension of the side-to- tube while removing it from the
socket.
side motion of the lamp head, use a
coin to turn the screw (A).
8. To replace the shade, position it as
2. To adjust the tension of the up- indicated in the diagram, then push it
and-down motion of the lamp head, back into the socket assembly mak-
use a coin to turn the screw (B). ing sure the shade "snaps" into place.
3. It should not be necessary to 9. Rotate the shade to the desired
make adjustments to part (C), as position for use.
the tension has been preset at the
10. Plug the lamp into a standard
factory. However, if you find that the
neck of the lamp is too loose, use a 120V socket. Your lamp is ready
coin to turn the screw (C) clockwise for use.
to tighten the arm tension.
11. To turn lamp on or off, depress
STEP 3: TUBE INSERTION/ rocker switch (I).
REPLACEMENT
1. Make sure the lamp is not plugged Please note that in operation,
into an electrical socket. OttLite
2. If the lamp has been in use, Enjoy your OttLite
allow it to cool for approximately Desk Lamp!
5 minutes before proceeding.
This lighting system is designed
3. Set the lamp upright on a flat for use with OttLite
surface. only (model number T13330 /
OLPL13TC). Use of other products
4. Rotate the shade (D) so that the voids the warranty and may result
notch (E) in the base of the shade is in damage to the lighting system.
CAUTION!
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or its service agent or a similar qualified person in order to avoid a hazard. Indoor use only.
Executive Desk Lamp
CAUTION! IMPORTANT SAFETY INSTRUCTIONS:
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) AS A FEATURE TO
REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE
PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A
QUALIFIED ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY INSERTED.
DO NOT ALTER THE PLUG.
CAUTION:
FULLY INSERT.
AVERTISSEMENT! IMPORTANTES DIRECTIVES DE
SÉCURITÉ:
CETTE LAMPE PORTATIVE EST MUNIE D'UNE FICHE POLARISÉE (UNE LAME PLUS LARGE QUE L'AUTRE). CE
DISPOSITIF DE SÉCURITÉ DIMINUE LE RISQUE DE CHOCS ÉLECTRIQUES PUISQUE LA FICHE NE S'INSÈRE DANS
LA PRISE QUE D'UN SEUL CÔTÉ. SI ELLE N'ENTRE PAS DANS LA PRISE, INVERSEZ-LA. SI ELLE N'ENTRE
TOUJOURS PAS, CONTACTEZ UN ÉLECTRICIEN QUALIFIÉ. N'UTILISEZ JAMAIS AVEC UNE RALLONGE SAUF SI
LA FICHE S'INSÈRE ENTIÈREMENT. NE MODIFIEZ PAS CE DISPOSITIF DE SÉCURITÉ.
AVERTISSEMENT:
DANS LA GRANDE FENTE ET POUSSEZ JUSQU'AU BOUT.
® tubes are not dimmable.
¡ PRECAUCIÓN! INSTRUCCIONES DE SEGURIDAD IMPORTANTES:
® Executive
ESTA LÁMPARA PORTÁTIL TIENE UN ENCHUFE POLARIZADO (UNA DE SUS PATAS ES MÁS ANCHA QUE LA OTRA)
COMO CARACTERISTICA PARA REDUCIR EL RIESGO DE UNA DESCARGA ELÉCTRICA. ESTE ENCHUFE ENCAJARÁ EN
CUALQUIER TOMACORRIENTE POLARIZADO SOLO DE UNA MANERA. SI EL ENCHUFE NO CALZA COMPLETAMENTE
tubes
® EN EL TOMACORRIENTE DÉLE LA VUELTA. SI AÚN NO ENCAJA, PÓNGASE EN CONTACTO CON UN ELECTRICISTA
CALIFICADO. NUNCA UTILICE UNA EXTENSIÓN A NO SER QUE EL ENCHUFE PUEDA SER TOTALMENTE
INSERTADO. NO ALTERE EL ENCHUFE.
PRECAUCIÓN:
ENCHUFE CON LA RANURA ANCHA, INSERTE TOTALMENTE.
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
POUR ÉVITER LES CHOCS ÉLECTRIQUE, INSÉREZ LE BOUT LARGE DE LA FICHE
PARA PREVENIR UNA DESCARGA ELÉCTRICA, HAGA COINCIDIR LA PATA ANCHA DEL