Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION BODYPACK TRANSMITTER KN-MICW430:
For use with system KN-MICW410 & 420
1. 3-pin mini XLR connector: for connecting the clip-on or headset microphone.
Use the instrument (line) cable to connect an instrument.
2. On/Off switch: power on and off
3. Low battery indicator: LED indicates battery status. Switching the power to
"ON", the LED flashing once indicates that the transmitter has sufficient power. If
the LED stays on, it indicates that the battery has insufficient power and the
battery should be changed soon. If the status LED fails to flash, the battery is
either dead or not positioned correctly, and you should correct the positioning or
change the battery.
5
.
4. Mic/Line selector: switch for microphone or line input
5. Antenna: high performance antenna.
6. Channel selector: select the channel
with the following combinations of the
switches. The chosen frequency must be
the same as chosen on the receiver
7. Gain: Adjustment for the output level of the signal from the microphone
(use mini screwdriver from the accessory set to adjust)
8. Cable: with mini XLR connector form clip-on of headset microphone
9. Battery compartment: insert two AA batteries into the compartment and
make sure that the polarity of batteries is correct
10. Microphone: the uni-directional electret condenser unit features a wide
frequency response for warm, rich bass and clear sound
11. Clip: To clip on the microphone to tie or other clothing piece
SYSTEM CONNECTION:
Connect the receiver to mixer or amplifier
1
2
3
4
CH
CH
CH
CH
5
6
7
8
CH
CH
CH
CH
9
10
11
12
CH
CH
CH
CH
13
14
15
16
CH
CH
CH
CH
6
.
Publicidad
