Acuity Brands DCMK 224 Instrucciones página 7

8
Raise front of fixture to ceiling and engage latches –

Gently push CPANL toward hinges to fully seat in back of bracket and rotate latch side of fixture up towards ceiling.

If tether is sticking out, push it so that it lays on top of panel. May need to align it so that clip does not prevent panel from going up fully.

Panel will need to be close enough to ceiling for locking feature on latch tab to clear opening in hanger bracket.

Rotate latches into closed position (both latches), see Figure 8A.

Latch tabs should be flush against side of fixture, see Figure 8B

Gently let down fixture to make sure latches are engaged.
Figure 8A
If the CPANL needs to be removed from the hanger bracket (not necessary during typical installation) –
 To unlatch: Lift latch side of panel toward ceiling to clear hook feature and pull on latches.
 Unclip the front tethers.
 Have someone hold ladder steady; and then securely take hold of panel and rotate latch side toward ceiling until the front is 12"-18" from
ceiling.
 Use your finger, or a flat head screwdriver, to push locking spring above mounting hinge, see Figure.
 Carefully slide the mounting hinge toward you, past the locking spring. Repeat on other side to fully free fixture.
 Lower panel to the ground and place on flat surface to avoid damaging the diffuser lens.
(2x)
Figure (only for CPANL removal)
12/8/2020 Rev C
CPANL SURFACE MOUNT KIT - INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION DE CPANL KIT DE MONTAGE EN SURFACE
INSTRUCCIONES DE INSTALACIÓN DE CPANL KIT DE MONTAJE EN SUPERFICIES
1
2
FOR ANY QUESTIONS, PLEASE CONTACT 1-800-705-7378
! PLEASE RETAIN THESE INSTRUCTIONS !
Figure 8B
CAUTION:
1) You should be able to gently pull the panel in any
direction without it disengaging from the mounting
bracket.
2) The DCMK Bracket is only intended for use on a smooth
flat ceiling surface.
Page 6 of 16