RoboCam ZC15 E Guia Del Usuario página 6

4. Setting up the Scan Pad Remote Control (CR14E)
The CR14E Remote control lets you move the position of an Xcam2 camera (attached to a Pan and
Tilt Base) from left to right (pan) and up to down (tilt). You can store 4 positions for a camera and
then use the remote to sweep between these positions.
Install 4 AAA alkaline batteries (sold separately) in the remote's battery compartment, and use a
screw driver to set its dial to the same Housecode as your camera's power supply.
Single camera operation
Press a left or right Blue button at the top of the CR14E Remote to "Pan" the camera left or right.
Press a Blue up or down button to 'Tilt" the camera up or down.
Buttons P1 through P4 are used to store 4 position settings for the camera.
1. Move the switch at the bottom from Normal to Program.To store the first position for the
camera, press the Blue buttons to scan to the position you want. Press P1.
2. To store the second position for the camera, press the Blue buttons to scan to the position you
want. Press P2.
3. To store the third position for the camera, press the Blue buttons to scan to the position you
want. Press P3.
4. To store the fourth position for the camera, press the Blue buttons to scan to the position you
want. Press P4. Move the switch back to Normal
Write camera location
here
Centers the camera
Set the same letter as
the Transceiver and
camera power supplies
(For multiple camera
systems).
«Tilts» up and down
«Pans» left and right
Pressing any of these turns on
that camera, and turns the other
3 off (Transceiver required).
Not necessary if you have just
one camera
Stores 4 positions for each
camera
Sweeps through the 4 stored
positions for the selected
cameras
Scans forward or backward through
cameras controlled by C1 through C4.
Hold to step every 6 seconds (for
multiple camera systems).
Page 5