Brixton KA-5319 Manual De Instrucciones página 6

Changing the gas cylinder
•
Gas cylinders must be replaced in a flame free environment.
•
Do not smoke while changing the gas cylinder.
•
Turn off the gas cylinder valve or regulator fully (clockwise) and take the empty cylinder out
of the heater.
•
Do not attempt to remove the regulator while the heater is still running.
•
Make sure that the heater is extinguished completely.
•
Remove the regulator from the empty cylinder.
•
Following the steps described under "Heater Set-up" for connecting a new cylinder.
Cleaning
•
Maintenance and cleaning must be carried out with the gas supply turned off and the heater
must be cold. Do not attempt to clean the heater while it is in use.
•
Your heater should be checked annually by a qualified person for safe operation and to
detect any faults.
•
If any faults are detected in use, stop using the heater and contact your dealer for advice.
•
Periodically clean the exterior and rear cylinder, storage area of your heater to remove dust,
which may affect the operation of the heater.
•
Light vacuuming with a soft brush will remove any dust build-up on the surfaces of the
ceramic elements. Do not scrape these elements as they may become very fragile with use.
•
Do not use abrasive products to clean the heater.
•
Watch the pilot flame while it is in operation. It should burn steadily, if it flickers or is yellow
tipped, the heater should be checked for correct operation.
•
If any parts need replacement, they must be replaced only with genuine original parts
supplied by the manufacturer. The use of incorrect or substitute the parts may be dangerous
and will void any warranty.
When the heater is not in use for a period of time, for instance, over the summer, we recommend
that it is kept covered or replaced in its carton to minimize the accumulation of dust and dirt that
may occur.
EN-5