Checklist Before Starting Engine - Snapper 020230 Manual Del Operario

3. Before connecting garden hose to water inlet, inspect
inlet screen (Figure 6). Clean screen if it contains debris
or replace if damaged. Refer to "O-Ring Maintenance"
section if inlet screen is damaged. DO NOT run
pressure washer if inlet screen is damaged.
Figure 6 — Connect Garden Hose to Water Inlet
4. Run water through your garden hose for 30 seconds
to clean out any debris.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 6).
CAUTION
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any flow
shut off device, such as a 'Y' shut-off connector or other
convenience-type water shut-off valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
2650 PSI Pressure Washer
6.
Inspect inlet
screen. DO NOT
use if damaged;
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
clean if dirty.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.

Checklist Before Starting Engine

Review the unit's assembly to ensure you have performed
all of the following.
1.
2.
3.
4.
5.
6.
7.
9
Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
WARNING
High pressure spray can cause paint chips or
other particles to become airborne.
Make sure handle is in place and secure.
Check that oil has been added to proper level in
engine crankcase.
Add proper fuel to fuel tank.
Check for properly tightened hose connections.
Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
Provide a proper water supply at an adequate flow.
Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using the pressure washer.