HYPERLITE 1426319 Manual De Usuario página 2

PRODUCT INSTRUCTIONS:
1. INFLATING YOUR SUP
• Remove the valve cover from the valve by unscrewing it ¼ turn
counter-clockwise until the valve cover releases.
• Make sure the air release valve is in the "UP" position by pressing down
with your thumb and turning to the right until it rebounds to the "UP" position
when you release your finger.
• You can check if the air release valve is in the "UP" position by pressing on the valve.
If it depresses then returns to the "UP" position, the valve is in the proper position
and your iSUP is ready to be inflated.
• Attach the hose from the pump to the valve by inserting the hose and turning
clockwise ¼ turn until the hose is securely attached to the valve.
ELECTRIC PUMP INFLATION INSTRUCTIONS:
• Plug the end of the cable into the 12 V outlet in your car to power on the pump.
• Make sure the pump display reads "PSI" on the LED screen.
• If the LED screen reads "BAR", push the "PSI/BAR" button once so it reads "PSI".
• Adjust your desired pressure to 15 PSI (1 BAR) by pushing the " + " and " - " buttons
until the display reads "15.00 PSI" (1 BAR)
• Push the power button to the start the pump.
The pump will automatically shut off when it reaches 15 PSI (1 BAR).
(*DO NOT EXCEED 18 PSI / 1.2 BAR)
• Remove the hose by quickly twisting COUNTER-CLOCKWISE while pulling
upward, away from the valve.
VALVE PIN "UP"
VALVE PIN "DOWN"
2