KORR KMAP001 Manual De Utilización página 3

B
A
FIGURE 1
FIGURE 2
A
B
FIGURE 3
VERY SHARP BLADE
C
D
WARNING
ASSEMBLY
Assemble the table assembly (Fig. 1-A)
Fig.1 to the blade assembly (Fig. 1-B) using
3 small Phillips head screws (Fig. 1-C) to
secure the top of the table. Use two larger
pan head screws (Fig.1-D) to secure the
table brace.
Assemble the handle (Fig. 2-A) to the top of
the blade assembly. First, loosen the three
fixing screws (Fig. 2-B) using a hex key.
Insert the handle shaft into the cylindrical
hole (Fig. 2-C), make sure the recessed hole
(Fig. 3-D) lines up with the center screw.
Once properly aligned and inserted, tighten
the center fixing screw using a hex. key.
Then tighten the other two fixing screws.
SETTING UP FOR OPERATION
The laminate flooring cutter is shipped with
the blade assembly in the down and locked
position. This safety feature ensures that
the cutting edge of the blade is not exposed
during transport or storage. To unlock the
blade assembly, loosen the safety lock knob
(Fig. 3-A), depress the handle then slide the
lock knob to the right to disengage the lock
(Fig. 3-B).
WARNING! Secure handle in the down
position and re-engage the safety lock
before storing, carrying or transporting
your laminate flooring cutter.
- 3 -
SET UP