Joyello JL- 976 PAPPERTUTTO Manual De Instrucciones página 14

GB
"AUTO" USAGE MODE
A) KEEP THE BABy BOTTLE WARM
B) RAPID BABy BOTTLE HEATING
C) STERILISATION
Use in the car only when the vehicle is stationary.
WARNING: in the "AUTO" mode, when using the same amount of water in the
tank, the time increases considerably, roughly doubling compared to the time
indicated in the table above.
The device should only be used with the car plug supplied.
1. Set the switch located on the bottom
of the baby bottle to the "AUTO" position
2. Set the control knob to "OFF" position
3. Place the baby bottle on a flat and stable surface
4. Ensure that the power cable is unplugged from the cigarette lighter
5. Insert the supplied car jack in the plug
6. Place the baby bottle containing the milk in the bottle warmer
7. Fill the bottle warmer with about 65 ml of water
8. Connect the product by inserting the jack into the cigarette lighter
9. Adjust the control knob to the desired function
10. The green light turns on, indicating that the bottle warmer is heating up
When the green light turns off, wait about half a minute and remove the baby bottle
STERILISATION FUNCTION 100°C
IN THIS CONFIGURATION THE PRODUCT SWITCHES OFF ONLy AFTER THE WATER
HAS EVAPORATED FROM THE TANK.
IN THIS FUNCTION THE SIGNAL LIGHT SWITCHES OFF ONLy By TURNING THE CON-
TROL KNOB TO "OFF".
Add max 10 ml of water to the tank.
After 5-7 minutes, even if the water evaporation cycle is not completed, turn the
control knob to "OFF", unplug the plug from the wall outlet, wait half a minute, and
then remove the baby bottle and/or steam-sterilized accessories.
14