Installation Instructions - Schön TL-6115HC-W Instrucciones De Instalación

E
1
F
D
A
1
E
1. Insert new floor bolts (E) into the slots on the toilet flange (1) (not
included) with the bolt heads down and threaded ends facing up.
Use plastic retaining washers (F) to hold the bolts (E) in a full-length,
upright position.
2. Floor bolts (E) should be parallel to the wall and 6 in. apart.
1. Turn the toilet (A) on its side onto a towel or cushioned surface.
A
2. With the rounded (tapered) end of the ring facing the toilet, place
the wax ring (D) around the raised outlet ring of the base (A), and
press firmly enough so the wax ring (D) adheres to the base (A).
1. Unplug the waste opening in the toilet flange (1).
2. Gently place the toilet (A) (right side up) in position with the floor
bolts (E) protruding up through the holes in the base of the toilet
(A). Level the toilet (A) as it is lowered onto the toilet flange (1).
3. Once the toilet (A) is in position, press down with a slight twisting
motion on the top center of the bowl (A) and eventually apply full
body weight to evenly compress the wax ring (D). This creates a
water-tight seal.
4. Ensure the toilet bowl (A) is as level as possible. It may be necessary
to use small wedges (shims) under the edge of the toilet due to
slight variations in vitreous chinaware or uneven oors.
IMPORTANT: The toilet (A) should be firmly seated on the floor, so it
does not wobble or rock.
CAUTION
Do not rock the bowl back-and-forth, as this may break the seal.
PAGE 4
1-Piece Dual Flush Toilet

Installation Instructions