Publicidad
Step 6
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40MA) to the RIGHT END (A) and RIGHT UPRIGHT (C). Use four GOLD 5/16" FLAT HEAD
å
SCREWS (3S) through holes #1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the END and UPRIGHT. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWER.
å
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
This large
hole must
be here.
Open end
www.sauder.com/services
40MC
These large
holes must
3S
be here.
4
3
2
C
1
A
3
4
420166
40MA
Open end
1
2
Page 11
Publicidad
