Publicidad
Step 11
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the RIGHT END (A) and RIGHT UPRIGHT (E) until the shoulders
å
of the SCREWS rest on the surfaces of the END.
NOTE: Do not overtighten the SCREWS.
å
Slide the RIGHT END MOLDINGS (K) onto the RIGHT END (A) and RIGHT UPRIGHT (E). Line up the grooves in the
å
MOLDINGS over the heads of the SCREWS in the END and UPRIGHT.
NOTE: The MOLDINGS should be even with the top edges of the END and UPRIGHT.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Apply pressure toward the UPRIGHT with
your hands as you guide the MOLDINGS
over the SCREWS and onto the UPRIGHT.
www.sauder.com/services
The groove should be against
the END and UPRIGHT.
K
E
K
A
422191
Shoulder
Apply pressure toward the END with
your hands as you guide the MOLDING
over the SCREWS and onto the END.
Shoulder
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
32S
Page 15
Publicidad
