Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HELPUL HINTS
Allow the wine cooler to remain open for a few
minutes after manual cleaning to air out and dry the
inside of the wine cooler cabinet
NOTE: Be certain the power is off before cleaning
any part of this appliance.
HOW TO CLEAN THE INSIDE
Never use any commercial or abrasive cleaners or
sharp objects on any part of the wine cooler.
Walls, Floors, Inside Window and Shelves:
Some water deposits and dust can be removed with a
dry paper towel, others may require a damp cloth.
HOW TO CLEAN THE OUTSIDE
Do not use cleaners containing ammonia or alcohol
on the wine cooler. Ammonia or alcohol can damage
the appearance of the appliance.
BEFORE YOU CALL FOR SERVICE
PROBLEM
1) No power.
2) Cabinet temperature too
high.
3) Condensation on the cabinet
and/or doors.
If none of the above rectify the situation please contact our customer care department at
CARE AND CLEANING
Outer Case:
It's important to keep the area clean where the door
seals against the cabinet. Clean this area with a sudsy
cloth. Rinse and then dry.
Door surface:
Use only mild, non-abrasive detergents applied with a
clean sponge or soft cloth. Rinse well.
Control Panel and Door:
Wipe with a damp cloth and dry thoroughly. Do not
use cleaning sprays, large amounts of soap and water,
abrasive or sharp objects on the panel- they can
damage it. Some paper towels may also scratch the
control panel and door glass.
TROUBLESHOOTING
POSSIBLE CAUSE
• A fuse in your home may be
blown or a circuit breaker tripped
• Power surge
• Plug is not fully insterted into
wall outlet.
• Temperature Setting.
• Door not shut properly or
opened excessively.
• Interior lights toggled on.
• Exhaust vent is obstructed.
• Recently added large quantity of
warm bottles to cabinet.
• High humidity conditions in the
home.
1-800-26-
(1-800-263-2629)
6
SOLUTION
• Replace fuse or reset circuit
breaker.
• Unplug the wine cooler, wait a
few seconds and plug back in.
• Make sure the 3-prong plug is
fully inserted into outlet.
• Verify the temperature control
setting; adjust if necessary.
• Ensure door is fully closed and
the gasket is sealing against the
cabinets. Open door only as
needed and for short periods of
time.
• The interior lights are intended
for temporary lighting of cabinets
for display purposes only. They
are not intended to be left on for
prolonged periods of time.
• Verify that nothing is blocking
front-mounted exhaust vent.
• Limit quantity of warm bottles
introducted at the same time.
Stagger the load introduction if
possible.
• Ensure door is fully closed and
gasket is sealing against the
cabinet. Open the door only as
needed and for short periods of
time.
Publicidad
Tabla de contenido
