Carton Contents; Overview (Fig. A) - Black and Decker GS1400 Manual Del Usuario

E N G L I S H
The earth wire should be of a length to ensure
that in the event of the cable being pulled
from the plug, the earth wire is the last to
break contact.
Before replacing the top cover of the mains
plug ensure that the cable restraint (3)
is holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.
If the plug has a fuse cover, make sure that the
fuse cover is fitted. Do not use the plug if the
fuse cover is missing or damaged.
Never use a light socket.
Using an extension cable
Always use an approved 3-core extension cable
suitable for the power input of this tool
(see technical data). The extension cable must be
suitable for outdoor use and marked accordingly.
When using a cable reel, always unwind the cable
completely.

CARTON CONTENTS

The carton contains:
1 Shredder body with chute
3 Legs
3 Leg retaining screws
1 Allen key
1 Instruction manual
Carefully unpack all parts.

OVERVIEW (fig. A)

1. On/off switch
2. Body
3. Chute
4. Rear leg
5. Front legs
6. Leg retaining screw
7. Thumb nut
ASSEMBLY
Before assembly, make sure that the tool
is switched off and unplugged.
10
Mounting the legs (fig. B, D1 & D2)
Loosen the thumb nut (7) and remove the
chute (3) (fig. D1 & D2).
Turn the shredder upside down and place it on
the floor.
Insert the rear leg (4) into the corresponding
opening in the body (2) as shown. Align the
screw hole (11) with the bottom of the slot (12).
Secure the leg with a retaining screw (6).
Insert both front legs (5) into the
corresponding openings in the body (2) as
shown. Align the screw hole (11) with the
bottom of the slot (12).
Secure each of the legs with a retaining screw (6).
Turn the shredder into the upright position and
refit the chute. Securely tighten the thumb nut.
USE
Let the tool work at its own pace.
Do not overload.
Do not switch the shredder off before it
is completely empty, as it may clog and
be difficult to restart.
Remove soil and stones from plant
roots before shredding.
Firmly hold branches when feeding
them into the shredder.
Switching on and off (fig. C)
To switch the tool on, set the on/off switch (1)
to position I.
To switch the tool off, set the on/off switch to
position O.
Hints for optimum use
Shred dry materials last, as this will help to
clear moist material from the shredder.
Do not allow material to pile up and compost
prior to shredding.
You may feed shreddings into the shredder for
a second time to further reduce their volume.
Refer to the chart at the end of this text.
MAINTENANCE
Your Black & Decker tool has been designed to
operate over a long period of time with a
minimum of maintenance.