Clip Connection; Adjust The Suction Output - WOLFF Starvac M/55 Manual Del Usuario

Remove the paper filter bag
Illustration
Release and remove the suction head.
Pull the paper filter bag out towards the
rear.
Pull the locking slide up and seal the pa-
per filter bag tightly when removing it.
Dispose off the used paper filter bag in
a dust-tight bag according to the statu-
tory provisions.
Insert and lock the suction head.
To suck wet dirt, first remove the paper
–
filter bag.
Remove the membrane filter.
Illustration
Release and remove the suction head.
Remove the membrane filter.
Insert and lock the suction head.
To vacuum wet dirt, always remove the
–
membrane filter (option).
Drain off dirt water
Illustration
Drain off dirty water through the drain-
age hose.
General
Warning
The flat pleated filter must must always be
in place while vacuuming.
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.

Clip connection

Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Turning on the Appliance
Plug in the main plug.
Switch on the appliance at the main
switch.

Adjust the suction output

Set the suction output (min - max) at the
rotary switch.
Working with electrical power tools
Danger
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.
Connect the mains plug of the electric
power tool to the vacuum cleaner.
Switch on the appliance at the main
switch.
Indicator lamp is on; vacuum cleaner is in
the standby mode.
Note: The vacuum cleaner is turned on and
off automatically with the electric power
tool.
Note: The vacuum cleaner starts automat-
ically within 0.5 seconds and continues to
run for 15 seconds after the power tool has
being switched off.
Note: Please refer to "Technical specifica-
tions" for the power connection specifica-
tions of the power tools.
Illustration
Adjust the stepped power tool adaptor
to fit the connection of the electric pow-
er tool.
Illustration
Remove the elbow from the suction
hose.
Attach the stepped power tool adaptor
to the suction hose.
4
-
EN
Operation
19