HON HON115900AFNN Manual Del Usuario

Illustration 1
Illustration 2
Pull (design
may vary)
DRAWER/DOOR PULL ASSEMBLY
Screw
Outside surface
of drawer
Pull (design
may vary)
Screw
Outside surface
of door
Read all instructions and review illustrations
before installing.
Tools required for assembly:
Phillips screwdriver
This assembly includes:
(2 or 3) Drawer/door pull (design may vary)
(4 or 6) Screw
NOTE
For shipping purposes, certain models will have
the drawer/door pulls pre-installed on the inside of
the drawers/doors. Use the phillips screwdriver to
remove and reinstall pulls as described below.
If included, discard plastic shipping spacers. Do
not reuse spacers for installation of pulls.
Drawer Pull Installation (refer to Illustration 1):
1. Open drawer and position pull onto outside sur-
face of drawer as shown.
2. From inside of drawer, use Phillips screwdriver to
install two screws through holes in drawer and into
pull. Fully tighten screws.
3. Repeat for all drawers.
Door Pull Installation (refer to Illustration 2):
1. Open door and position pull onto outside surface
of door as shown.
2. From inside of door, use Phillips screwdriver to
install two screws through holes in door and into
pull. Fully tighten screws.
3. Repeat for all doors.
242-7438A
(7/05)