Overmax X-bee 9.5 Manual De Usuario página 44

2.
When flying, press , to make the drone land automatically.
See: fig. 24.
EN
ATTI mode
To disable GPS, slide the remote control on/off switch as presented in fig.
25. In this mode, the drone does not use GPS to keep its position. To keep
the altitude, the built-in altimeter is used. This mode is not precise and
therefore you must be experienced and skilled at flying the drone.
GPS mode
Turn GPS switch into position specified in fig. 27. In this mode, the drone
will use GPS to keep its position.
How to return home
The return function is used to make the drone return to recently saved spot
(„home"). There are three modes of the function: smart return, emergency
return and low-battery return.
The saved spot is the place in which the drone takes off. To make sure this
spot is properly remembered, GPS signal must be strong enough (at least
7 connected satellites at the take-off).
1. Smart return
If GPS signal is available (more than 7 satellites) and starting point has
been saved, press the return key. The drone will return to the saved spot.
When returning, you can control the drone in order to avoid obstacles, for
instance. Press the key again to leave the return function.
2. Emergency return
If GPS signal is good (more than 7 satellites) and starting point has been
saved, the emergency return will be initiated automatically when the remote