Taurus 947891 Manual De Instrucciones página 4

3.3. Installing the foot stands
3.3.1. Install the 2 foot stands on the bottom of the
heater.
3.3.2. Put 4 screws into the holes for each foot.
3.3.3. Fasten the screws with the screw driver.
3.4. Operating instructions
3.4.1. After mounting the heater in your prefered
way, insert the plug into the wall socket and ensure
that the mains power is turned on.
3.4.2. Turn the heater on by pressing either one, or
both of the power setting buttons.
3.4.3. Select your desired temperature by adjusting
the variable temperature control.
4. Cleaning
4.1. Disconnect the appliance from the mains power
supply and allow it to cool completely before under-
taking any cleaning task.
4.2. Clean the outer parts of the appliance with a
damp cloth with a few drops of washing-up liquid
and then dry. CAUTION! Do not immerse electrical
parts of the appliance in any liquid.
4.3. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.4. Never submerge the appliance in water or any
other liquid or place it under running water.
4.5. The air filter may become clogged with dust and
dirt over time. It is important to clean the air filter
regularly to ensure maximum operation efficiency. .
Remove the grill for the inflow of air from back part
of the device. Remove the air filter from the grill.
Wash the filter by hand in a lukewarm solution of
water and detergent. Then rinse the filter in clean
water and allow it to dry thoroughly. Place the clean,
dry filter back into the back grill and attach it to the
device. Do not use the device without the filter and
back grill being installed.
5. Anomalies and repair
5.1. Take the appliance to an authorised support
centre if product is damaged or other problems
arise.
5.2. If the connection to the mains has been dam-
aged, it must be replaced and you should proceed as
you would in the case of damage.