Texi Zorro 110 Free Manual De Usuario página 26

TEXI Zorro 110 Free operation manual
Cutting
1. Prepare working place properly as well as material which you are going to cut.
2. Adjust height of the front protective blade guard (1) by pushing it up. Be sure that guard
is on the height which allows you to cut required layers of material, but still covers the
blade on the rest of the surface. NOTE: power must be switched off while adjusting
front protective cover.
3. Switch on the power and start cutting. Adjust the knife to appropriate speed and LED
light.
Do not touch blade or any moving parts of the knife when you operate it.
Charging the battery
Cutting machine is delivered with charger and 2 rechargeable batteries.
Before removing / replacing battery always switch the power off.
1. Switch off the power button.
2. Remove battery from the slot.
3. Place battery in the charger and connect charger cable to the appropriate power
socket (220V).
4. After 120 minutes battery should be loaded. It will be indicated by green light on the
charger.
5. Disconnect charger from the power supply.
6. Install battery into the cutting machine (check chapter "Battery installation")
26