Maintenance And Storage; Technical Data - LUND 67201 Manual Del Usuario

Device operation
Keep the nozzle outlet close to the surface to be cleaned. Steam deposited on the surface to be cleaned should be rubbed off
before it evaporates on its own. This can be done with the puller pad, cloth pad or with a cloth or paper towel.
Repeat cleaning in the case of dirt which is harder to remove.
Caution! Do not use the device to clean windows at low temperatures. Cold glass can break when it comes in contact with hot
steam.
Do not steam clean surfaces which cannot be wet cleaned.
During operation, the amount of water in the tank must be constantly monitored. If the capacity of the device decreases, it can
mean that the water in the tank has to be replenished. Do not allow an empty water tank to be heated. This can lead damage to
the device, or result in an electric shock or fi re.

MAINTENANCE AND STORAGE

After use, disconnect the product from the power supply by pulling out the power cord plug and wait until the water in the tank
has cooled down completely. Then unscrew the tank cap and empty the tank completely by turning the device upside down. Then
leave the device with the tank open until the remaining water from the tank has been completely dried. After drying the tank, screw
the cap back on.
The cloth pads will be damp after use, remove them and leave to dry. Pads can be washed in mechanical washing machines at
temperatures up to 60 degrees C. Do not dry mechanically and do not iron.
Clean the housing of the unit with a slightly damp cloth, then dry or leave to dry. Never immerse the device housing in water or
other liquids. Do not use alcohol, solvents, corrosive or abrasive agents for cleaning.
Do not use sharp objects for unclog the nozzles. Clogged nozzles must be replaced with new nozzles before further use.
Store the product in dry, shaded and well ventilated places. The place of storage should protect the device from access by unau-
thorised persons, especially children. It is recommended to store the product in the packaging it was delivered in.

TECHNICAL DATA

Parameter
Cat. No.
Rated voltage
Rated frequency
Rated power
Water tank capacity
Steam pressure
Maximum steam temperature
Capacity
Ingress protection rating
Protection class
Weight
O R I G I N A L
GB
Units
[V~]
[Hz]
[W]
[l]
[MPa]
[ O C]
[g/min]
[kg]
I N S T R U C T I O N S
Value
67201
220 - 240
50/60
900 - 1050
0,4
0.3
110
28 - 40
IPX4
I
0.9
11