Sleep Function; I-Feel Function; Lock Function; Installation Of Wired Controller - Airwell RCW8 Manual De Instrucciones

WIRED CONTROLLER RCW8

3.7 SLEEP Function

Press SLEEP Button to activate the SLEEP operation
Press this button again, the function stops.

3.8 I-Feel Function

Under Cool, Heat and Auto mode, press the I-Feel button , the function is activated.
Press again, the function will be effective.
3.9 Electrical Heater
Press the E-Heater button in heat mode, Electrical heater function will be effective.

3.10 Lock Function

Press the LOCK button, all current settings are locked and the wired remote control
does not accept any operation except the LOCK button.
Press the LOCK button again to cancel the LOCK function.
3.11Reset Button
Use a 1mm stick to press the little hole, then current settings is canceled. The wired
remote control enters into original state.
4
OPERATING INSTRUCTION

Installation of Wired Controller

IV
4.1 Installation of Wired Controller
2
1
3
Fig.4 Sketch for Installation of Wired Controller
Table 1
No. 1 2
Front panel of Baseplate of
Description Screw M4X25
controller controller
Fig.4 Sketch for Installation of wired controller. Pay attention to the following items
during installation of wired controller:
3.2 How to install the wired controller:
First of all, the selection and connecting method of the communication line is shown
as follows:
(1) Select appropriate communication line of the wired controller: 5-core shield wire
Wire size ≥ 0.5mm2, length <20m, recommended length: 6m
(2) After the indoor unit is powered off, then the specific installation steps are shown
in the Fig.4
WIRED CONTROLLER RCW8
Tab A/B/C/D/E
3
5
INSTALLATION