Chicago Pneumatic CP9205L Instrucciones De Manejo/Instrucciones De Seguridad página 7

Before operation of the car jack it is necessary to ventilate the hydraulic circuit. Insert the lever into the recess and attach it using the
supplied screw.
Afterwards turn the lever clockwise as far as possible, hold it in this position and pump several times. Then release the lever to allow it
to return to its original position (watch the dog control). The car lever is now ready for use. All model have a foot pedal, which facilitates
lifting operation up to the load. Please refer to the vehicle's manual for correct lifting points of the vehicle.
To lower the load, slowly turn the lever clockwise. Our car jacks are furnished with a safety device which ensures a slow descent speed
subject to the load size by automatic control. Aways make sure after descent, the lever arm is completely retracted.
Afterwards turn the lever clockwise as far as possible, hold it in this position and pump several times. Then release the lever to allow it
to return to its original position (watch the dog control). The car lever is now ready for use. All model have a foot pedal, which facilitates
lifting operation up to the load. Please refer to the vehicle's manual for correct lifting points of the vehicle.
To lower the load, slowly turn the lever clockwise. Our car jacks are furnished with a safety device which ensures a slow descent speed
subject to the load size by automatic control. Aways make sure after descent, the lever arm is completely retracted.
• Safety guidelines specifed under point 4 are to be observed during work with the jack at all times.
• Lowering the load
• In order to lower the load, please turn the hand wheel counter-clockwise SLOWLY as shown in the picture.
• The hydraulic unit (pump) is a sealed system, which only requires lubrication of the moving parts under normal working conditions
once a month. If the hydraulic unit was disassembled to replace worn out gaskets, or because oil leaked out, fll oil into the pump
slowly through the opening of the oil screw (pos. 54).
• When changing oil, at least once a year, or reflling oil, use oil to fll the cylinder up to the oil intake screw. Please make sure that the
piston is retracted.
• All moving parts must be lubricated at regular intervals. Keep the device always clean and away from aggressive chemicals. Do not
leave the jack outdoors.
• The oil level in the tank may not exceed the flling plug position, when the piston is completely retracted.
• Following table gives information about the required amount of oil and type of oil:
CAUTION!! Never use brake fuid. Too much oil in the pump may cause the device to stop operating.
Additionally, oil or lubrication must be applied to mechanical parts every 2 months
All damaged, severely worn out or poorly functioning devices MUST BE TAKEN OUT OF OPERATION and labeled with stoppage card.
Repair must be done by a technical expert authorized by the vendor.
The product must be disposed of or recycled according to legislation of the corresponding country.
5. Startup
6. working with the tool
7. Maintenance
Quantity 0,5
[l]
Type HPL ISO 32
8. Damaged devices
9.Disposal of devices
7 / 15 - © CP