Installing The Lamp - ALSY Lighting 22167-000 Guia De Inicio Rapido

Installation
1

Installing the lamp

□
Pull out any excess power cord through the lamp base (A) during all assembly steps to prevent the cord from becoming twisted.
□
Assemble all tubes (C) onto the tube (B).
□ Insert the whole assembled tubes into the lamp base (A). Adjust the lamp in the correct position and ensure that the lamp is stable, then
tighten the metal washer (I) and hex nut (J) by using the wrench (K) which is included.
PRO TIP: To avoid cross
threading during assembly,
slowly turn one of the
poles counter clockwise
while pressing the pole
ends together until a click
is heard or felt. Then, turn
the same pole clockwise
until the threads engage
and align correctly.
2
Installing the lamp shade
□
Thread the balance pole (D) clockwise to the joint (E).
□
Remove the socket ring (H) and rubber washer (M) from
the socket assembly (F).
□
Place the shade (G) onto the socket assembly (F), re-attach
the rubber washer (M) and socket ring (H) to secure the
shade (G).
F
G
M
H
C
C
C
Remove
it before use
A
I
J
E
www.evolutionlightingllc.com
WARNING- risk of tipping if not assembled
properly – arm & glass shade must be centered
directly above base.
B
K
3
Installing the light bulb
□
Install the light bulb (not included) into the socket assembly (F).
□
Adjust the shade (G) to position the light as desired.
□
Loosen the knob on the joint (E) and adjust the lamp arm
to the desired position. Retighten the joint knob to secure.
□ Use the rotary switch (L) on the tube (C) to turn the lamp ON
and OFF.
F
D
G
For Customer Assistance:
Made in China
2
E
L
C