English - Kenwood CM170 Serie Manual De Instrucciones

safety
● Watch out for steam, never lift the
tank lid during the brewing cycle or
touch the hotplate.
● Keep children away from the
machine. And never let the cord
hang down where a child could
grab it. Push excess cord inside the
back of the machine (CM170 series
only).
Never use a damaged machine. Get
●
it checked or repaired: see 'service
and customer care'.
Never put the machine in water or
●
let the cord or plug get wet - you
could get an electric shock.
Unplug:
●
before filling with water
● ●
before cleaning
● ●
after use.
● ●
Never leave the machine on
●
unattended.
Don't let the cord touch hot parts.
●
Always make sure there is water in
●
the tank before switching on.
●
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
●
Children should be supervised to
ensure that they do not play with the
appliance.
●
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Remove all packaging.
2 Wash the parts: see 'care and
cleaning'.
3. Push excess cord inside the back of
the machine (CM170 series only).
4. Run two lots of water through the
machine (without coffee) to clean it
out. Fill the tank to the top cup mark
when you do this. See 'to make
coffee'.
key
filter door
permanent coffee filter (or use a
paper filter instead)
water tank
compartment for excess cord
(CM170 series only).
on/off switch with indicator light
measuring spoon
jug
hotplate
to make coffee
1 Pour water into the tank. The water
must be between the top and
bottom cup marks. Then close the
lid.
●
Use cold water. We recommend
using filtered water from a Kenwood
Water Filter as it reduces limescale.
Never use warm or fizzy water.
●
If you use the jug to fill the tank, look
at the tank marks, not the jug marks.
They're slightly different to allow for
the fact that some of the water gets
absorbed by the coffee.
2 Open the filter door.
2