English - Kenwood CM650 Serie Manual De Instrucciones

safety
●
Never let the cord hang down over
the worktop edge - a child could
grab it and pull the machine down.
Push excess cord inside the back of
the machine.
●
Always make sure there is water in
the tank before switching on.
●
Never use a damaged coffee maker.
Get it checked or repaired: See
'service and customer care'.
●
Never put the machine in water or let
the cord or plug get wet.
●
Watch out for steam and never
touch the hotplate.
●
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
●
Children should be supervised to
ensure that they do not play with the
appliance.
●
Only use the appliance for its
intended domestic use. Kenwood will
not accept any liability if the appliance
is subject to improper use, or failure
to comply with these instructions.
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Remove all packaging.
2 Wash the parts: see 'care and
cleaning'.
3 Push excess cord inside the back of
the machine.
4 Run two lots of water through the
machine (without coffee) to clean it out.
Fill the tank to the top cup mark when
you do this. See 'to make coffee'.

English

Please unfold the front page illustrations
key
hotplate
compartment for excess cord
filter door release button
permanent coffee filter (or use a
paper filter instead)
filter holder
filter door
on/off switch with indicator light
(model CM650 only)
additional features on the
CM660
strength control indicator light
strength control button
auto/on/off indicator light
auto/on/off button
automatic timer light
automatic timer button
hour button
minute button
to set the clock (model
CM660 only)
(the clock does not have to be set in
order for the coffee maker to
operate)
1 Plug into the power supply.
2 Press the hour and minute buttons
until the correct time is shown. Make
sure when selecting the hour that
AM or PM is correctly selected.
●
Providing the appliance remains
connected to the power supply the
clock will keep the correct time, if it
is unplugged the clock will flash
12:00.
to make coffee
1 Pour water into the tank. The water
must be between the top and
bottom cup marks. Then close the
lid.
●
Use cold water. We recommend
using filtered water from a Kenwood
Water Filter as it reduces limescale.
Never use warm or fizzy water.
●
If you use the jug to fill the tank, look
at the tank marks, not the jug marks.
They're slightly different to allow for
the fact that some of the water gets
absorbed by the coffee.
2