Care & Cleaning - Kenwood CM370 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
4 Turn the handle on the water filter
holder and align the arrow on the
base with the letter for the current
corresponding month eg F for
February.
5 Lower the water filter holder into the
water tank and fit into position in the
recess.
6 Fill the tank with the desired amount
of water. The water must be
between the top and bottom cup
marks. Do not fill above the MAX
level. (Alternatively fill the water tank
when fitted inside the coffee maker
but take care not to cause spillage.)
Use cold water. We recommend
using filtered water from a Kenwood
Water Filter as it reduces limescale.
Never use warm or fizzy water.
7 Replace the water tank back into the
coffee maker.
8 Ensure the filter holder is in position
in the coffee maker.
9 Fit either the permanent filter
supplied or a paper filter into the
filter holder. Add the coffee, use the
spoon provided (approximately 1
level spoon per cup or to taste).
10 Close the lid and adjust the aroma
control as required. Turn the control
to the left for stronger coffee and to
the right for weaker coffee.
11 CM370 series
Put the carafe on the hotplate.
CM380 series
To achieve the best performance,
rinse the thermal carafe with hot
water immediately before switching
on the coffee maker.
Screw the lid onto the thermal
carafe. For brewing, the lid should
be fully closed with the tab on the
lid in line with the carafe handle. Put
the carafe on the base.
12 Plug in and switch on, the light will
glow.
13 Don't remove the carafe until
brewing has finished.
CM370 series
The hot plate will keep your coffee
hot, but the sooner you drink it, the
better it will taste.
It is recommended to only keep the
machine switched on for a
maximum of 2 hours providing there
is coffee in the carafe. Do not leave
the machine switched on with an
empty carafe on the hotplate.
CM380 series
To pour coffee after brewing has
finished, unscrew the lid 180° so
that the tab on the lid is in line with
the pouring spout. Once the desired
amount of coffee has been poured,
screw the lid back on to best retain
the coffee temperature.
As soon as all the coffee has
brewed, switch off and unplug the
machine.
If you haven't used the machine for
a while, run one lot of water through
it (without coffee) to clean it out. Fill
the water tank to the top cup mark
when you do this.
Never put the carafe in the
microwave.
care & cleaning
Always switch off, unplug and allow
to cool before cleaning.
Never put the machine in water or let
the cord or plug get wet.
Don't wash parts in the dishwasher.
water filter
Change and discard the water filter
after 70 brewing operations or within
a calender month whichever is
sooner.
carafe, lid, permanent filter,
filter holder, water filter
holder
Wash, then dry.
body
Wipe with a damp cloth, then dry.
Don't use abrasives - they'll scratch
the plastic and metal surfaces.
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cm380 serieCm375 miro

Tabla de contenido