Installation Instructions - Brunner CLS-E Guia De Inicio Rapido

2 INSTALLATION INSTRUCTIONS

GENERAL
Open the box carefully and remove all packaging.
The following material is included:
1. CLS-E Joystick
2. USB Cable
3. 36V Power supply with cable
5. This manual
MOUNTING & OPERATING CONDITION
1. The unit must be mounted with 4 Screws securely on a flat surface before operating.
2. Keep a minimum of 5 cm distance around the unit from any part.
3. Keep environmental temperature below 40°C max. Use only in dry environment.
4. Variants delivered without GRIP: Install your grip (TM Hotas / VPC Mongoos T-50),
please refer to Chapter 3: GRIP INSTALLATION
FIRST START / ELECTRICAL CONNECTION
1. Connect the provided power supply to Power Plug.
Attention! AC Main power plug must be unplugged
2. Connect the CLS-E Joystick with your computer via the provided USB cable.
3. Connect the delivered AC main power plug to the Power Supply and connect the
power cable to the AC-power outlet. The calibration and initialization sequence will
start automatically. Axis are moving across their range.
DO NOT DISTURB THIS SEQUENCE UNTIL THE JOYSTICK IS CENTERED!
THIS SEQUENCE IS REPEATED EVERY TIME WHEN POWER IS APPLIED.
4