PPDCM80
4.15 Capacitance
Warning
Electric shock hazard.
Turn off all power and discharge all capacitors before making resistance
measurements.
• Turn the rotary switch to the
mode.
• Connect the red test lead to the INPUT jack and the black test lead to the COM
jack.
• Connect the test leads to the capacitor to be measured.
• Read the measured capacitance on the display.
Note:
1. When measuring large capacitances, wait a few seconds for readings to stabilize.
This is normal for high capacitance measurements (>4mF).
2. To improve the accuracy below 10nF measuring value, subtract the distributed
capacitance of meter and cable.
4.16 Continuity
Warning
Electric shock hazard.
Turn off all power and discharge all capacitors before making resistance
measurements.
• Turn the rotary switch to the
mode.
• Connect the red test lead to the INPUT jack and the black test lead to the COM
jack.
• Connect the test leads to the circuit under test.
• Read the measured resistance on the display.
•
Note:
display will show "OL."
position.Press
once to switch to capacitance
position. Press
- 18 -
EN
2 times to switch to diode