Setup Menu - Sony PDBK-102 Instrucciones De Instalación

Setting item
F1: INPUT

Setup menu

• Brackets [ ] indicate characters and symbols that appear in the time data display section.
• An asterisk (*) (for example *EE) indicates that a setting is the factory default.
INTERFACE SELECT [Interface]:
Settings related to interfaces
i.LINK MODE [> i.LinkMode]:
Select the type of connection for
the S400 connector.
Points to note when connecting to a nonlinear editor
• Set INTERFACE SELECT >i.LINK MODE in the setup menu of the PDW-F70/F30/
70MD/F75/75MD to "TS".
• Before writing material that you have edited on a nonlinear editor to a disc in the PDW-
F70/F30/70MD/F75/75MD, change the settings of the STOP item under AUTO EE
SELECT in the setup menu to "EE".
• If you are unable to input or output video even after connecting an i.LINK cable, connect
the i.LINK cable again, making sure to push its plug straight in.
The following table shows the relation between the system frequency of the PDW-F70/F30/
70MD/F75/75MD and the operation of the TS board.
SYSTEM SEL
60I
50I
30P
25P
23.98PsF
23.98P (2-3 pulldown)
The unit does not synchronize to the reference video signal input to the REF VIDEO INPUT
connector when there is a TS connection. Disconnect the i.LINK cable if you need external
synchronization. The following table shows the relation between TS connection and external
synchronization.
Description
Selects the input signal.
i.LINK: Signal i.LINK
SG: Test signal from the internal signal generator
Description
*AV/C [>> AV/C]: AV/C connection.
FAM(PC REMOTE) [>> FAM]: FAM connection.
TS [>> TS]: TS connection
TS operation
OK
OK
Operates as 60I
Operates as 50I
No input or output
Output as 60I
Overview 19