Lid Assembly; Additional Precautions - Drive PreserveTech Manual Del Usuario

The lid is preassembled at the time of delivery but can be replaced if necessary. To
do this, turn the body of the raised toilet seat around and press the lid clips at the
same time. The lid can then be taken out of the holders.
• Inspect all parts for shipping damage before assembly. If there is shipping damage
- DO NOT USE. Contact dealer/carrier for further instructions.
• Check for secure fit routinely before using product. User's weight should be
centered over toilet seat, not too far forward or too far to one side, as unit
may tip.
• Use the arm supports only for assistance. DO NOT attempt to use the arms to
support full body weight.
• The lid must not be used as a backrest in the opened position.
• The lid must not bear a load when closed.
Drive recommends periodic visual inspection of this product by the user, to ensure that
all parts and hardware are secure, that components are in good working order and not
worn, torn, frayed, loose, or rusted and that there are no obstructions or impediments
to normal, safe operation. If any part or mechanism appears to be unsafe or
compromised, do not use the product. If you experience problems, please contact the
provider that sold you the product or visit www.drivemedical.com/help for more info.
NOTE: To maintain the beauty of the original finish, clean with mild soap and rinse with
warm water. Wipe bath seat dry after each use.
Drive PreserveTech™ products are manufactured with an antimicrobial* agent that helps
to minimize the growth of stain and odor-causing bacteria and mold on treated surfaces.
*Antimicrobial properties are built in to protect the products. These products do not
protect users or others against bacteria, viruses, germs or other disease organisms.

lid assembly

additional precautions

maintenance
PreserveTech
S t a y s C l e a n e r • L a s t s L o n g e r
TM