Controller Installation - Tronsmart TF12 Manual Del Usuario

INSTALLATION
1. Connect the SATA power connector to any available SATA
connector from your system power supply.
2. Connect the RGB light strip into ① port (The RGB light strip is
not included).
3. Connect the fans in sequential order from 2＞3＞4＞5＞6＞7＞8.
Animations begin with fan 2 and proceed through fan 8. Any fan
not connected in series will break communication and the RGB
LED lighting function will not work.
4. Plug the 2-pin data cable into SW connector and then connect
the RESET button or other 2-pin port of the computer chassis to
switch the light mode.
5. Connect the USB cable with your computer through USB port
to achieve lighting control by Tronsmart Radiant software.
6. Plug the 4-pin cable into CFIN connector, then connect to the
computer motherboard to automatically detect the temperature
of the CPU and smart control the rotating speed of the RGB fan.

CONTROLLER INSTALLATION

1. Turn your system off before installing the controller.
2. Mount the controller with the provided mounting cable.
3. Plug the mini USB cable into the back of the controller, and then
plug the 9-pin end into an available internal USB 2.0 connector in
your system.
DOWNLOAD TRONSMART RADIANT
For the full Tronsmart Radiant light experience, please download
our latest software at www.tronsmart.com/tronsmart-radiant.htm
Note: An internet connection is required for software download.
Tronsmart Radiant is required for lighting control.