Logitech Squeezebox Duet Guia Del Usuario página 4

Logitech Squeezebox Duet
Charge the Li-ion battery pack
1. Fit the adapter onto the AC adapter plug of the charging station. Make sure the
adapter snaps into place.
2. Plug the AC adapter into an electrical outlet.
. Insert the Li-ion battery pack into the controller:
• Remove the battery cover on the back of the controller. Use your thumbs to press
down on the battery cover, and then slide it toward the bottom of the unit.
• Insert the battery pack, making sure the This Side Up label faces up and reads
correctly.
• Place the battery pack end—marked with three arrows—into the battery slot first.
• Replace the battery door, fitting the tabs on the door into the slots on
the controller.
• Slide the battery door up toward the top of the controller so it locks into place.
4. Place the controller into the charging station. The controller powers on and the
battery pack begins charging. It may take up to four hours to charge the battery pack
fully. However, you do not need a full charge to set up the controller.
6 English
Acquire your network settings
If you can connect your computer to a Wi-Fi network, you should have little difficulty
setting up Squeezebox Duet. Gathering information about your network now will make it
easier to set up the Squeezebox Duet network music system.
Network name (SSID): ____________________________________________________
Security Key: ____________________________________________________________
If your network is secured, you will need to enter the security key when you set up
the controller. It is important that you know the type of network security your access
point uses, and that you have the security key ready before you start. More information
on Wi-Fi networking can be found in the Squeezebox Duet User Guide. If you are not
sure about your network security setup, contact your ISP or the company that installed
your Wi-Fi router. To find your network settings, do one of the following:
Windows : Click Start > Run, type cmd and press Enter. In the DOS window,
®
type ipconfig and press Enter.
Macintosh
® OS X: Go to System Preferences > Network. Under the Show:
drop-down, pick the network interface you are using, and then click TCP/IP.
Your IP address is displayed.
Linux: Open up a shell and type ifconfig and press Enter.
User's Guide
English 7