Uline H-3616 Manual Del Usuario página 3

ASSEMBLING CABINET
1. Place the back (1) on a protected surface. The
bottom flange should be facing upward. Panels will
overlap slightly. Bolt panels together using 7 bolts and
nuts. (Nuts on the inside of the unit.) (See Figure 1)
Figure 1
BOTTOM
NOTE: When bolting the unit together, leave the
bolts slightly loose until step 7, unless otherwise
specified.
2. Attach the left side (3) to the back by placing flange
under the back and bolting the back and sides
together. Be sure that the shelf supports on all shelf
adjustment strips point up on both back and side.
(See Figure 2)
Figure 2
1
PAGE 3 OF 15
ASSEMBLY INSTRUCTIONS
1
TOP
3
3. Attach the top (4) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the top over the side panel. The threaded studs
should go through the holes in the top flange of the
side and fasten with 3 nuts. Attach the back to the
top using 4 bolts and nuts. (See Figure 3)
3
Figure 3
Threaded studs
go through the
holes in the
flange at the
top of the side.
4. Attach right side (2) in the same manner used in
step 2. Make sure the side flange overlaps the back
panel and the flange on the top is over the right
side. Push the side panel up so the studs in the top
go through the holes in the top flange of the side.
Fasten with 3 nuts. (See Figure 4)
Figure 4
3
1
4
1
2
0321 IH-3616