Cleaning And Maintenance - SEA 23102076 Manual De Instrucciones

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
Operational Verification
Fit one of the black plastic photocell covers complete with an opaque diffuser label stuck across the lens.
- Check that the relay works correctly.
- Check that the red led goes out when the beam is broken.
Red led Function:
RED LED LIT: CORRECTLY ALIGNED. NORMAL QUIESCENT STATE.
RED LED UNLIT: INCORRECTLY ALIGNED OR BEAM INTERRUPTED.
SECURITY
The 23102076 device cannot be used as security device (EN 12978).
SPARE PARTS
To obtain spare parts contact:
SEA s.r.l. - Zona Ind.le, 64020 S.ATTO - Teramo - Italia.
INTENDED USE
The photocell 23102076 has been projected to be used exclusivley as photoelectric barrier to be installed in
the areas considered dangerous and in proximity of the gate/ leaf, it must be used exclusively for the
functioning as interposition between transmitter and receiver (installed according to the above mentioned
instructions) and must be power supplied with safety tension.
ENVIRONMENT
Please dispose of this product packaging in a responsible, appropriate way.
CONFORMITIES
The 23102076 photocell conforms to the following:
89/336/CEE (Act on the Electromagnetic Compatibility)
STORING
T
min
-20 °C
When being transported this product must be properly packaged and handled with care

CLEANING AND MAINTENANCE

Cleaning and maintenance of this unit must be carried out at 6 monthly intervals by authorised, qualified
personnel. During routine maintenance the following checks should be made: Correct alignment, sealing,
cleanliness of the lenses and internal components. Any remedial work should be carried out as required.
DECOMMISSIONING
If the 23102076 photocell is to be taken out of service, this work must only be undertaken by authorised,
qualified personnel.
LIMIT OF GUARANTEE
The 23102076 photocell is guaranteed for a period of 24 months. The guarantee period starts from the date
stamp printed on the product. The guarantee will be void if the photocells have been incorrectly installed, not
used for the purpose intended, tampered with or modified in any way. The validity of this guarantee only
extends to the original purchaser.
NOTE: THE MANUFACTURER CAN NOT BE DEEMED RESPONSIBLE FOR ANY DAMAGE OR INJURY
CAUSED BY IMPROPER USE OF THIS PRODUCT.
SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to
notice.
Cod. 67410885
®
SEA S.r.l.
DIREZIONE E STABILIMENTO:
Zona industriale 64020 S.ATTO Teramo - (ITALY)
Tel. 0861 588341 r.a. Fax 0861 588344
STORAGE TEMPERATURES
T
max
+70 °C
English
Humidity
5% no condensation
Rev. 03 - 09/2009
http://www.seateam.com
e-mail:seacom@seateam.com
Humidity
min
90% no condensation
max
Pag. 2