Zehnder RF55 Manual De Instalación página 38

With an active pairing mode
on a ventilation unit, there are
10 minutes to pair one CO
For each additional CO
paired, the ventilation unit must be
put into active pairing mode again.
2. Press the operating button for 5 seconds
to activate the menu:
1. The three LEDs on the right blink
green 3 times.
2. The CO LED blinks green.
2
3. The bottom LED on the right flashes
red and the CO
indicate the RF pairing option.
3. Press the operating button for 5 seconds
to confirm the RF link selection.
■ T he three LEDs on the right blink red
3 times to confirm the activation of
the RF link.
4. Briefly press the operating button and
select one of the desired parings:
■ T he bottom LED on the right turns
red: this is the standard pairing
mode. The CO
the RF address of the ventilation unit.
Previously registered units remain
active.
■ T he middle LED turns red: this is the
pairing mode to register an additional
ventilation unit to the CO
The ventilation unit takes over the
RF address of the CO
Previously­registered units must then
be paired again in standard pairing
mode.
Only use the pairing method described
below if a new RF address must be
assigned to the ventilation unit.
38 - EN
Sensor.
2
Sensor to be
2
LED flashes green to
2
Sensor takes over
2
Sensor.
2
Sensor.
2
■ T he top LED turns red: this is the
pairing mode to generate a new
RF address for the ventilation unit.
Previously­registered units must then
be paired again in standard pairing
mode.
5. After the above selection, press the
operating button for 5 seconds to
confirm the selection. After this, the
pairing between the CO
ventilation unit starts.
1. The CO LED flashes orange, and the
2
selected pairing mode LED flashes
red. The ventilation unit is being
sought. This may take some time.
2. The CO LED flashes orange and the
2
selected pairing mode LED flashes
green. Previously paired CO
are being sought. This may take
some time.
3. The pairing worked: The three LEDs
on the right blink green 3 times.
4. The pairing failed: The three LEDs
on the right blink red 3 times.
6. Repeat the complete procedure for
pairing the next CO
resetting the ventilation unit to active
pairing mode.
Pairing a CO
2
1 minute.
If the pairing has failed, try pairing
the CO Sensor by holding it closer
2
to the ventilation unit.
Sensor and the
2
Sensors
2
Sensor, including
2
Sensor usually takes