Using The Product; Reversing The Door - Kunft KSD2531 Manual De Instrucciones

2.2. Using the Product

Installation
Important! For electrical connection carefully follow the instructions
given in specific paragraphs.
• Unpack the appliance and check for any signs of damage. Do not
connect the appliance if it is damaged. Report possible damage
immediately to the place you bought it. In this case, retain the
packaging.
• It is advisable to wait at least four hours before connecting the
appliance, to allow the oil to flow back in the compressor.
• Adequate air circulation should be provided around the appliance;
otherwise this may lead to overheating. To achieve sufficient
ventilation follow the specific installation instructions.
• Wherever possible the spacers of the product should face a wall
to avoid people touching or getting snagged on heated parts (the
compressor and condenser), and thus avoid possible burns.
• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of
the appliance.

Reversing the door

Tool required: Philips screwdriver, Flat bladed screwdriver, Hexa-
gonal spanner.
• Ensure the unit is unplugged and empty.
• To take the door off, it is necessary to tilt the unit backwards. You
should rest the unit on something solid so that it will not slip during
the door reversing process.
• All parts removed must be set aside for the reinstallation of the door.
• Do not lay the unit flat as this may damage the coolant system.
• It is recommended that 2 people handle the unit during assembly.
1. Remove the two screws at rear side of the
top cover.
Unscrew
2. Remove the top cover and set it aside.
8
refrigerator single door
3. Unscrew the top hinge and then remove
the door and place it on a soft pad to avoid
scratching.
4. Unscrew the bottom hinge of the freezer
door. Then remove the door and place it on a
soft pad to avoid scratching.
5. Move the door holder from the left side to the right side.
6. Move the hinge hole cover from the left side
to the right side.
7. Rotate the freezer door and place the hinge
on the left side. Then fix the door onto the
holder.
Note: remove
this screw if it
presents.
8. Unscrew the bottom hinge. Then remove the
adjustable feet from both sides.
9. Unscrew and remove the
bottom hinge pin, turn the
bracket over and refit it.
Unscrew
EN
KSD2531
Screw
9