Operating Instructions; Product Description; Interior Fittings; Using The Product - Kunft KDD2529 Manual De Instrucciones

2. OPERATING INSTRUCTIONS

2.1. Product Description

1. Ice cube tray (optional)
2. Metal freezer shelf
3. Temperature control knob
4. Storage shelves
5. Fruit and vegetable crisper cover
6. Fruit and vegetable crisper

Interior Fittings

Storage Shelves and Metal Shelves
Your device is supplied with plastic or glass storage shelves as well
as metal shelves - different models have different combinations.
Always place one of the glass storage shelves at the lowest possible
position above the fruit and vegetable crisper, and keep it in this
position.
The height of the storage shelves can be adjusted. To do this, pull
the shelf forward until it can be lifted and removed. Do the opposite
to insert a shelf at a different height.
In order to make the most of the storage space in the fresh food
compartment and the frozen food compartment, you can remove one
or more shelves and/or drawers from the appliance, tailoring it to
your daily use.
8
refrigerator double door

2.2. Using the Product

Removing Transport Packaging
The equipment and interior fittings are secured for transport. Remove
the tape from the left and right sides of the door. Use alcohol to
remove any tape residue. Remove all tape and packing materials
from inside the appliance.

Positioning the Appliance

• Place the appliance away from heat sources such as ovens,
radiators, direct sunlight, etc.
• The appliance may not function properly if it is exposed to a
temperature above or below the indicated values for a long period
of time.
• This appliance should not be exposed to rain.
• There must be sufficient airflow in the lower rear section of the
appliance, since poor air circulation can affect its performance.
• Built-in appliances should be placed away from heat sources, such
as heaters and direct sunlight.
Note: You must have good ventilation around the appliance to allow
effective heat dissipation, high efficiency cooling and low power
consumption. To this end, there should be enough space around the
appliance. It is advisable for there to be 75 mm between the back of
the fridge and the wall, at least 100 mm of space on both sides, 100
mm above the top and a clear space in front to allow the doors to open.

Door Reversing

The side on which the door opens can be
changed from the right side to the left side, if
the installation site requires.
Before you start, lay the refrigerator on its back
in order to gain access to the base, you should
rest it on soft foam packaging or similar material
to avoid damaging the cooling pipes at the rear
of the refrigerator.
Before reversing the door's position, perform
these steps:
• Move the accessory (1) from the upper cover
of the upper door, and then transfer it to the
other side of the upper cover.
• Loosen and remove the screws (3) and the
stops (2 and 4) of the upper and lower doors
and insert them into their respective holes
on the opposite side of the door. Tighten the
screws.
EN
KDD2529
9