Hydor Koralia Serie Manual De Instrucciones página 8

placed in the later. Be sure that the voltage of the mains supply corresponds to the voltage shown on the
unit's label. In order to prevent noise and disturbance caused by vibration we suggest to position the pump
avoiding lateral contact with the aquarium glass or in an upward position on the bottom.
Unwind the electric cable.
•
Insert the cylinder on the sphere attachment to the pump in the proper slot -Fig. 2-.
•
If necessary apply the cable protector (G) (ideal use is tanks with urchins, triggers, puffers and/or parrot fish)
•
as shown in Fig. 3, protecting the submerged part of the cable. If the cable protector is too short, you can
apply more then 1 (available for purchase code XP 2922 - USA code XP 2923).
Immerse the pump completely and turn it in a vertical position in order to allow any air to come out of the
•
impeller chamber.
Attach the pump with the internal part of the suction cup + magnet support to the aquarium side as desired
•
-Fig. 4- (remember to clean the surface before attaching the support).
Holding with one hand the pump attached inside the aquarium, place the external part of the magnetic
•
support on the outside of the aquarium at a distance of approx. 10 cm (4 inches) from the centre of the
internal support. Slowly move the external support until you feel the attraction between the magnets and
place them so that the centres are on the same axis -Fig. 5-.
Direct the water fl ow as desired.
•
Connect to electrical supply.
•
maintaneance
attention: before any kind of intervention, ALWAYS disconnect electrical supply of the pump and any other
appliance placed in the water.
Regular cleaning and maintenance will guarantee the pump better and longer performance.
•
With one hand hold the pump assembly, with other hand remove the external magnet to release.
•
Disassemble as shown -Fig. 6 -7-.
•
Clean the impeller assembly, the chamber and the bearings removing deposits with a soft
•
Brush (code XT0803, not included). Do not use detergents or solvents.
•
If necessary clean the grid of the lower and upper chamber by putting it under running tap water or using a
•
soft brush to remove algae and/or other residue.
Reassemble everything in reverse order, make the rotor holder is placed correctly -Fig. 8-.
•
In case of abnormal noise and /or reduced performance caused by sudden changes in electricity supply, it
•
is sufficient to restart the pump
Guarantee
The device is guaranteed for a period of 24 months from the date of purchase, against defects in material
and/or workmanship. Our guarantee does not apply to claims the cause of which is due to installation
and operation faults, lack of maintenance, misuse of the device, effects of frost, furring and lime deposits
or amateur repair attempts. The consumable materials and parts subject to wear and tear, that must
be periodically replaced for normal maintenance of the device, are not included in our guarantee. The
certificate of guarantee must be completed by the retailer and is to be sent with the device in case of return,
together with the purchase receipt recording the date of purchase.
european union disposal information
This symbol means that according to local laws and regulations your product should be disposed
of separately from household waste. When this product reaches its end of life, take it to a
collection point designated by local authorities. Some collection points accept products for free.
The separate collection and recycling of your product at the time of disposal will help conserve
natural resources and ensure that it is recycled in a manner that protects human health and
the environment.
8 English