PIEPS DSP Manual página 15

AddITI OnA L Fun CTI O n S FO R PIEP S dSP
The following additional functions are only valid for PIEPS DSP. The functions cannot be
activated at PIEPS DSP Tour.
1. SCAn-FunCTIOn
Press the SCAN button while in the SEARCH-mode. The PIEPS DSP will begin scanning the
entire receiving range. During the scan, stand still and hold the device steady. This will give
you an overview of all the buried devices within the detectable range, classiied according to
three groups:
Reading 1: beacons within a distance of approx. 5m
Reading 2: beacons within a distance of approx. 20m
Reading 3: beacons within a distance of approx. 50m
All information from previously
suppressed (MARKED) signals
will be reset and you can start
the suppression again (MARK)
or follow the direction indication
to the next strongest signal.
IMPORTAnT! Once you have
located all burials, move away
from their locations in a star
shape and use the SCAN function
to check the scenario again. That
way you can make sure you
haven't missed any other burials.
28 | 06/12
3
2
1
1 One beacon
within 5 m
2
Two beacons
within 20 m
3
Four or more
beacons within 50 m
2. FREQuEnCY MEASuREMEnT
Press the ENTER button while in the SEARCH-mode. The PIEPS
DSP uses the frequency measurement to check the frequency of all
other beacons. The frequency of the strongest (closest) beacon is
measured. The deviation from the standardized frequency 457kHz
is indicated. The shown number is the deviation in Hz and the
arrows indicates + (right) or – (left).
IMPORTAnT! Check the transmitting frequency of your partners
on tour regularly. According the standard EN300718 a beacon
must transmit within the range of 457 kHz +/- 80 Hz. Ideal and
reasonable technical operation will have a maximum deviation of
no more than +/- 30 Hz.
3. SWITCHInG FunCTIOn TO TX600 SEARCH
The PIEPS TX600 is a mini-transmitter for dogs
and equipment that is transmitting out of the
standard, EN300718 and can be received with
every PIEPS DSP (Version 8.2). Press the ENTER
and SCAN buttons simultaneously while in the
SEARCH-mode. The PIEPS DSP switches into
the TX600-mode and indicates the direction
and distance to the strongest TX600 signal. To
activate the search according to the standard
EN300718 again, switch the PIEPS DSP to the
SEND-mode and then back to the SEARCH-
mode.
IMPORTAnT! In the standard SEARCH-mode the PIEPS DSP does not indicate the TX600.
Active search operations are never inluenced. A detection of the TX600 without switching to a
special mode is only possible in immediate vicinity (<1 m).
06/12 | 29