Sicce Flower LED Basic Manual De Instrucciones página 7

To connect the flower to the big base, unscrew the small support, then fasten the ring nut and support
bracket to the treaded connector on the big support base. The big support base is provided of a hook
to easily connect several lights together and create a row of flowers (Pic. 3).
The light is attached to a bracket that allows it to move 90° vertically and 360° (full angle) horizontally;
therefore, the light beam can be directed as desired even once the flower is positioned in your pond
or garden (Pic. 4).
Before moving the bracket, slightly unscrew the ring nut that connects the bracket to the base.
INSTALLATION AND USE - version with PUMP AND WATER FEATURES (Pic.5)
Plug the flower's cable into the transformer and tighten the ring nut.
Connect the included tube (T) to the pump's outlet (P) and to the bottom of the flower (F) (opposite side
of the led). If you use the FLOWER LED without the complementary water feauture (Daisy G) you will
obtein a Geiser water play, on the contrary by adding the water play (G) you will have a small daisy,
which will require a more frequent maintenance.
Place the transformer at least 2mt - 7.2 ft distant from the tank or pond perimeter. Connect the
transformer to the power socket.
MAINTENANCE
Before performing any operation, unplug the transformer from the power socket.
FLOWER LED PLUS with JET KIT
To perform periodic maintenance, take the pump out of water. Clean the pump and rotor regularly
(Pic. 6).In case of very hard water or many residues, it is advisable to clean the pump and rotor more
frequently. Proceed as follows: Take the prefilter off the pump, turning the inlet tube toward right or left
(Pic. 6 c). Then take out the rotor (Pic. 6 f). Clean all parts and their chambers under running water.
Do not use hard objects to remove buildup, instead use a soft brush and soap or vinegar. Wear of the
rotor or shaft can provoke a slight noise. If after cleaning the pump makes noise, we advise replacing
the rotor and shaft with new parts.
The flower is watertight and sealed. LEDs cannot be replaced. In case LEDs fail, replace the whole flower.
At the end of the season, rinse the device under running water, using a soft brush.
INSTRUCTIONS FOR THE CORRECT DISCHARGE OF THE PRODUCT ACCORDING TO EU
DIRECTIVE 2002/96/EC
When used or broken, the product does not have to be discharged with the other waste. It can be
delivered to the specific electric waste collection centres or to dealers who give this service. Discharging
electric tools separately avoids negative consequences for the environment and health and allows the
materials to be recycled so to have a great saving of energy and resources.
WARRANTY
This product is guaranteed against defects of materials and workmanship for a period of 2 years from
the date of purchase. The warranty certificate must be filled in by the dealer and must accompany
the pump if it is returned for reparation, along with the cash register receipt or similar document.
The warranty covers the replacement of the defective parts. In case of improper use, tampering or
negligence by the buyer or user, the guarantee is void and expires immediately. The guarantee is also
void in absence of the cash register receipt or similar document. The expenses for shipping the pump
to and from the factory, or the repair station, have to be paid by the buyer.
7