Owner's Record - Sony AC-80MD Manual De Instrucciones

Owner's Record

The model and serial numbers are located at
the rear. Record these numbers in the space
provided below. Refer to these numbers
whenever you call upon your Sony dealer
regarding this product.
Model No. ______________
Serial No. ______________
WARNING
To reduce the risk of fire or electric
shock, do not expose this
apparatus to rain or moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
No modification of this equipment
is allowed.
THIS APPARATUS MUST BE
EARTHED.
This unit has no power switch.
To disconnect the main power,
unplug the power plug.
When installing the unit,
incorporate a readily accessible
disconnect device in the fixed
wiring, or connect the power plug
to an easily accessible socket-
outlet near the unit.
Do not position the ME equipment
where it is difficult to unplug the
power plug.
If a fault should occur during
operation of the unit, operate the
disconnect device to switch the
power supply off, or unplug the
power plug.
2
GB
Symbols on the products
Consult the Instructions for
Use
Follow the directions in the
Instructions for Use for parts of
the unit on which this mark
appears.
This symbol indicates the
manufacturer, and appears next
to the manufacturer's name and
address.
For the customers in the U.S.A.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/
TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
All interface cables used to connect
peripherals must be shielded in order to
comply with the limits for a digital device
pursuant to Subpart B of part 15 of FCC
Rules.